Research Journal of Engineering and Technology

(An international Research Journal of Engineering Sciences and Technologies)

Journal of Engineering and Technology invites Research paper in below mentioned fields of engineering for its first publication due in the next quarter.

1. Civil

2. Pharmacy

3. Mechanical

4. Chemical

5. Electrical

6. Electronics

7. Computers

8. Biomedical

9. Aeronautical

10. Agricultural

11. Environmental

12. Polymer

13. Textile

14. Food Technology

15. Dairy Technology

16. etc…..

Send a soft copy of your articles.

Contact :

Dr. K.N.Jayaveera

M.Sc. Ph.D.,FIC.,MISTE.,

Professor of Chemistry

Former Director of OTRI

Off : 0855 – 273013

Resi : 08554 – 274677

Cell : 09441489324

Email : knjayaveera@gmail.com , India@frozen-flavors.com

SUBMISSION OF MANUSCRIPTS:

Typewritten manuscripts prepared using MS word should be submitted in triplicate and RW-CD to Editor – in – Chief Research journal of Engineering and Technology, Plot no 22, Vidyut Nagar, Ananthapur – 515001, Andhra Pradesh, India. Ph.No.08554 274677, Mobile: 9441489324.Email: rjet.jntu@gmail.com , rjet.jntu@yahoo.com.

All components of the manuscript must appear within a single electronic file: references. Figure legends and tables must appear in the body of the manuscript.

TYPING INSTRUCTION :

The following detailed instructions are necessary to allwed direct reproduction of the manuscript for rapid publishing. If instructions are not followed, the manuscript will be returned for retyping. The following type faces, in 12 points size, are preferred: Times Roman.

GENERAL FORMAT: The typing area must be exactly 6 5/8” (168mm) wide by 9 7/9” (250mm) lon. Justify margins left and right (block format). The entire typing area of each page must be filled, leaving no wasted space, Text should be double-spaced, special care should be taken to insure that symbols, superscripts and subscripts are legible and do not overlap onto lines above or below, Make sure text lines are equidistant.

TITLE:

On the first page of the manuscript start title 1”(25mm) down from top text margin. Type title in all capital letters, centered on the width of the typing area and single spaced if more than one line is required. The title should be brief, descriptive and have all words spelled out. Double space, then type the author(s) name(s), single-spaced if more than one line is required. Double- space, than type author(s) address(es), single – spaced, capitalizing first letters of main words. Quadruple –space before Abstract.

ABSTRACT: Centre, type and underline abstract heading, capitalizing the first letter. A double-space should separate the heading from the abstract text. Indent abstract text approximately1/2” (13mm) from both left and right margins. The abstract should be intelligible to the reader without reference to the body of the paper and be suitable for reproduction by abstracting services. Introduction to the text (without a heading) should being four spaces below the abstract using full margins.

KEY WORDS: Three or more key words must be provided by authors for indexing of their article. Key words will be listed directly below the Abstract. Spell out entirely, using the official nomenclature.

MAJOR HEADINGS: Papers must include the major headings: Introduction, Methods, Results, Discussion, Acknowledgments and References. Capitalize first letter, underline, and centre headings on width of typing area.

TABLES/FIGURES: Incorporate tables and /or figures (B&W) with their legends into the main body of text.

REFERENCES: References should be referred to a number (1) in the text and be listed according to this numbering at the end of the paper. Only papers and books that have been published or in press may be cited; unpublished manuscripts or manuscripts submitted to a journal but which have not been accepted may not be cited.

The references should comprise the following information and in the given order and with given punctuation as given in the example below: Author name (s), Initials (s), Publication Title, Page Number, Year of Publication.

Standard Journal Article:

[1] Rao, G.S. and Kalra, M.L; The Indian Concrete Journal, December 1964,Vol.38, No. 12, PP.448-451.

Book:

[1] D.C. White and H.H. Woodson, Electromechanical Energy Conversion. New York: John Wiley & Sons, 1959, PP.100-108.

Proofs will be sent to the corresponding author. These should be returned as quickly as possible.

The facts and view in the article will be of the authors and they will be totally responsible for authenticity, validity and originality etc. The Authors should give an undertaking while submitting the paper that the manuscripts submitted to journal have not been published and have not been simultaneously submitted or published elsewhere and manuscripts are their original work.